Operator`s manual

6 - English
TM
Table 3
Connection Icons
Icon Definition
Video Out
Video Connect
(SeeSnake System Connector)
Transmitter Clip-on Terminal
Table 4
CS10 Screen Icons
Icon Name / Meaning
Loading Icon
Saved Icon
USB Icon
Corrupt Thumb Drive in USB Port
Icon
Job Saving Icon
Saving to USB Icon
Insert Thumb Drive Icon
Thumb Drive Ejected Icon
Thumb Drive Error
Thumb Drive Full Icon
Autolog Icon
Autolog Saving Icon
Autolog Not Saved Icon
Video Icon
Video Saving Icon
Video Not Saved Icon
Photo Icon
Photo Saving Icon
Photo Not Saved Icon
External Power Icon
Pre-Operation Inspection
WARNING
Before each use, inspect your CS10 and correct
any problems to reduce the risk of serious injury
from electrical shock or other causes and prevent
machine damage�
1� Confirm that the power is OFF, that any external
power and cords are disconnected, and that the
battery is removed� Inspect the cords, cables, and
connectors for damage or modification�
2� Clean any dirt, oil, or other contamination from the
CS10 to aid in inspection and to prevent the unit
from slipping from your grip during transport or use�
3� Inspect the CS10 for any broken, worn, missing,
misaligned or binding parts, or any other condition
which might prevent safe, normal operation�
4� Inspect any other equipment being used per its
instructions to make sure it is in good, usable
condition�
5� If any problems are found, do not use the unit until
the problems are corrected�
Work Area and Equipment Set Up
WARNING
Set up the CS10 and work area in accordance with
these procedures to reduce the risk of injury from
electrical shock, fire, and other causes and to prevent
damage to the CS10�
1� Check work area for the following:
• Adequate lighting�
• Flammable liquids, vapors, or dust that may ignite�
If present, do not work in area until sources have
been identified and corrected� The CS10 is not
explosion proof� Electrical connections can cause
sparks�