Full Product Manual

Wet/Dry Vac Assembly
1. Position the Powerhead Assembly on
the Drum/Caddy Assembly, as shown
(assembled earlier).
2. Rotate both Latches down and press
until you hear them snap over the
Flanges on the Drum.
Drum
Latch
Drum
Latch
Drum
Flange
Latch
Drum
Powerhead
Assembly
Insert Hose
Insert the Push Button end of the
Professional Locking Hose into the Vac
Inlet. The Professional Locking Hose
should snap into place.
To remove the Professional Locking Hose
from the Vac, press the Hose Assembly
Release Button and pull the Professional
Locking Hose out of the Vac Inlet,
as shown.
Press the Curved Metal Extension Wand
into the Coupling Ring of the Professional
Locking Hose End.
Join the two Metal Extension Wands,
aligning the Button and Hole so they
snap together.
Attach the Accessories, aligning the
Button and Hole so they snap together.
Release
Button
Press
and
Pull
Coupling
Ring
Accessory
Metal
Extension
Wand
(Curved)
Metal Extension
Wand (Straight)
Wet/Dry Vac &
Hose Assembly
11
Metal Wand
Button
Accessory
Hole
SP6729-5 RIDGID ESF 111418.indb 11 12/3/18 11:18 PM