Technical data

--- 17 ---
Fig. 8
8-1-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(1) Mounting the saw blade mount (Figs. 8, 9 and 10)
Insert Spring (B) [15] and Holder Pin (B) [14] into the Plunger [3]. Apply Shell ALVANIA RL3 grease to the
slanted portion of Lever (A) [12]. Mount the shorter end of Spring (D) [13] into Lever (A) [12] then mount
Lever (A) [12] into Blade Holder (A) [1]. Keeping this state, insert the tip of Plunger [3] into Blade Holder (A)
[1]. At this time, fit Spring (D) [13] in the groove of the Plunger [3] securely. Tighten the Special Bolt M4 [10]
and Nut M4 (Black) [2] at the specified torque. Push the Cap [11] to Lever (A) [12] from the side so that the
arrow mark on the Cap [11] points downward. At this time, check that there is no gap between the Cap [11]
and Blade Holder (A) [1]. Be careful not to break the Special Bolt M4 [10] by overtightening with an M5
hexagonal wrench. Finally, mount and dismount the saw blade to check for operation.
Fig. 9
Fig. 10
[12]
[15]
[14]
[3]
[13]
[1]
[3]
[14]
[12]
[11]
[10]
[13]
[15]
[1]
[11]
[10]
[13]
[3]
Groove of plunger
[2]