Technical data

ManualsBrandsRIDGID ManualsSawR3121

100

Commissioning

2.6 First commissioning control mode vector U/f in booksize format

Commissioning Manual

Commissioning Manual, (IH1), 01/2011, 6SL3097-4AF00-0BP1

What to do? How to do it? Comment

2.6 Motor data You can enter the motor data from the rating plate here.

If known, mechanical data for the motor and drive train can be

entered.

Equivalent circuit diagram data: No

If you do not enter any

mechanical data, it is

estimated on the basis of

the data on the rating plate.

The equivalent circuit

diagram data is also

estimated on the basis of

the data on the rating plate

or determined by means of

automatic motor data

identification.

2.7 Motor brake Here, you can configure the brake and activate the "Extended

brake control" function module.

For further information see

Function Manual.

2.8 Drive functions You can choose the application and motor data identification

here.

Motor data identification: "1"

Your choice of application

influences the calculation

for the open-loop/closed-

loop control parameters.

When the pulses are

enabled, a one-off

identification run is carried

out. Current flows through

the motor which means that

it can align itself by up to a

quarter of a revolution.

Once the measurement is

complete, optimization with

rotating motor is carried out

the next time the pulses are

enabled.

2.9 Important

parameters

You must enter important parameters in accordance with the

relevant application.

Note, for example, the general mechanical conditions for the

drive train.

2.10 Summary The drive data can be copied to the clipboard for system

documentation purposes and then pasted into a word processing

program, for example.

Note

The reference parameters and limit values in the STARTER can be protected from being automatically overwritten by

p0340 = 1. In the STARTER, you will find this under Drive -> Configuration-> Reference parameters / blocked list tab.

3. Enable signals and

BICO

interconnections

The enable signals for the infeed and the two drives must be

realized via the digital inputs on the Control Unit.