Technical data

Preparation for commissioning
1.5 Rules for wiring with DRIVE-CLiQ
Commissioning Manual
Commissioning Manual, (IH1), 01/2011, 6SL3097-4AF00-0BP1
31
1.5.4 Wiring example for parallel connection of Motor Modules in vector control mode
Drive line-up with two parallel-connected Line Modules and Motor Modules in chassis format of the
same type
Parallel-connected Line Modules in chassis format and Motor Modules in chassis format of
the same type can be connected to a DRIVE-CLiQ socket of the Control Unit.
In the following diagram, two Active Line Modules and two Motor Modules are connected to
the X100 or X101 socket.
For further information on parallel connection, see the chapter "Parallel connection of power
units" in the SINAMICS S120 Function Manual.
Note
This topology does not match the topology created offline by STARTER and must be
changed manually.
;
;
;
;
,QIHHG
;
;
;
$FWLYH
/LQH
0RGXOH
;
;
;
$FWLYH
/LQH
0RGXOH
;
$FWLYH
,QWHUIDFH
0RGXOH
;
$FWLYH
,QWHUIDFH
0RGXOH
;
;
;
6LQJOH
0RWRU
0RGXOH
;
;
;
6LQJOH
0RWRU
0RGXOH
;
;
'5,9(&/L4
&RQWURO
8QLW
0
960 960
'ULYH
60&

(QFRGHU
3RZHU
Figure 1-7 Drive line-up with parallel-connected power units in chassis format