Technical data

Commissioning
2.7 First commissioning, vector control mode in the chassis format
Commissioning Manual
104 Commissioning Manual, (IH1), 01/2011, 6SL3097-4AF00-0BP1
What to do? How to do it? Comment
Motor temperature Thermistor selection: via Motor Module (11)
Temperature sensor type: KTY84 (2)
Response to overtemperature: alarm and fault
(no reduction of I
max
)
Fault message for thermistor failure: ON
Deceleration time: 0.100 s
Alarm threshold: 120.0° C
Fault threshold: 155.0° C
6.
7. Save the parameters
on the device
Target device -> Copy from RAM to ROM Position cursor on drive unit and
right-click.
8. The motor starts to
run.
The drives can be started via the control panel in
STARTER.
 Line/DC link identification will be carried out once
the pulses for the infeed have been enabled and
line/DC link identification has been activated. The
infeed then switches to operational mode.
 When the pulses are enabled, a one-off motor
data identification run (if activated) is carried out.
 When the pulses are enabled again, optimization
with a rotating motor (if activated) is carried out.
For more information about the
control panel, see Getting Started.
During motor data identification, a
current flows through the motor,
which means that it can align itself
by up to a quarter of a revolution.
For more information about line/DC
link/motor data identification, see
the SINAMICS S120 Function
Manual.
Diagnostics parameters (see the SINAMICS S120/S150 List Manual)
● r0002 Infeed/drive operating display
● r0046 Missing enable signals (for more information, see "Diagnostics")