Use and Care Manual

11 — English
NOTE: ILLUSTRATIONS START ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
LED rapidly flashes, tool does not cycle Magazine is low or out of nails Load more nails in the magazine
LED slow flashes or no flash after pulling
the trigger (partial or no cycling)
Battery charge is low
Blade is not retracted properly:
jam in the guide
jam in drive system
Check charge levels or replace battery
Remove the drive giude cover, check for
jams or debris. Clear from driver guide.
Tool may need to resync the blade posi-
tion for nail.
LED continuous slow flashes after a fully
charged battery is inserted. (no cycling)
Major tool malfunction Take the tool to the nearest authorized
repair center
Tool operates properly, but fasteners do
not drive fully
Nail is too long for wood hardness
Depth of drive is incorrect
Use nail length that is appropriate for
wood
Adjust depth of drive appropriate for
wood
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten bolts
Clean magazine
Tool will not drive a fastener or cycles
without driving a fastener
Driving mechanism is dirty Clean the nail channel as described in
the Maintenance section of the manual
Nails do not drive properly Damaged drive blade or driver guide Take the tool to the nearest authorized
repair center