Manual

micro CA-300 Inspection Camera
10
Camera is not explosion proof and can
cause sparks.
 •Clear,level,stable,dryplaceforoperator.
Do not use the inspection camera while
standing in water.
2. Examine the area or space that you will
be inspecting and determine if the micro
CA‑300 Inspection Camera is the correct
piece of equipment for the job.
 • Determinetheaccesspointstothespace.
The minimum opening the cam era head
can t through is approximate ly
3
/
4
”
(19 mm) in diameter for the 17 mm cam‑
era head.
 • Determinethedistancetotheareatobe
inspected. Extensions can be add ed to
the camera to reach up to 30’ (9 m).
 • Determineifthereareanyobstaclesthat
would require very tight turns in the
cable. The inspection camera ca ble can
go down to a 5” (13 cm) radius without
damage.
 • Determineifthereisanyelectricalpower
supplied to the area to be inspected. If
so, the power to the area must be turned
OFF to reduce the risk of electric shock.
Use appropriate lock out procedures to
prevent the power from being turned
back on during the inspection.
 • Determineifanyliquidswillbeencoun‑
tered during the inspection. The cable
and imager head are waterproof to a
depth of 10’ (3 m). Greater depths may
cause leakage into the cable and imager
and cause electric shock or damage the
equipment. The handheld display unit is
water resistant (IP65) but should not be
submerged in water.
 • Determineifanychemicalsarepresent,
especially in the case of drains. It is im‑
portant to understand the specic safety
measures required to work a round any
chemicals present. Contact the chemical
manufacturer for required information.
Chemicals may damage or degrade the
inspection camera.
 • Determine the temperatureofthearea
and items in the area. The working tem‑
perature of the inspection camera is be‑
tween 32°F to 130°F (0°C to 55°C). Use
in areas outside of this range or contact
with hotter or colder items could cause
camera damage.
 • Determineifanymovingpartsarepres‑
ent in the area to be inspected. If so,
these parts must be deactivated to pre‑
vent movement during inspection to
reduce the risk of entanglement. Use
appropriate lock out procedures to pre‑
vent the parts from moving during the
inspection.
If the micro CA‑300 Inspection Camera is
not the correct piece of equipment for the
job, other inspection equipment is available
from RIDGID. For a complete listing of RIDGID
products, see the RIDGID catalog, online at
www.RIDGID.com or www.RIDGID.eu.
3. Make sure the micro CA‑300 Inspec tion
Camera has been properly inspect ed be‑
fore each use.
4. Install the correct accessories for the ap‑
plication.
Operating Instructions
WARNING
Always wear eye protection to protect your
eyes against dirt and other foreign objects.
Follow operating instructions to reduce the
risk of injury from electrical shock, entan‑
glement and other causes.
1. Make sure that the Inspection Camera
and work area have been properly set up
and that the work area is free of bystand‑
ers and other distractions.
2. Press the Power Button for one second.
The imager lights should come ON, then
a splash screen will appear. This screen
tells you the device is booting up. Once
the product is fully powered up, the
screen will automatically switch to the
live screen.