Specifications

8
Assembly (continued)
Mounting Inlet Guard
1. From the loose parts bag find the following:
4 Hex Screws, M8 x 1.25-12
4 Lockwashers, 5/16
4 Flat Washers, 5/16 x 11/16 x 1/16
2. Find the following:
1 Filtration Housing
1 Inlet Guard.
3. Carefully turn the filtration housing upside down so that
the motor end bell rests against the floor.
4. Support the opposite side of filtration housing with a
block of wood.
A. Place O-ring in relief of inlet pipe.
5. Position inlet guard in line with the threaded holes on
the base of the filtration housing.
NOTE: Make sure inlet guard is pointing to rear of
machine.
6. Place lockwasher and flat washer on hex screw and
inset through the holes of the inlet guard into the
threaded holes of the filtration housing as shown.
7. Complete the process for the other three holes using
same method.
Mounting Support Legs
1. From the loose parts bag find the following:
4 Hex Screws, M8 x 1.25-12
4 Lockwashers, 5/16
4 Flat Washers, 5/16 x 11/16 x 1/16
2. Find the following:
1 Left Leg Support
1 Right Leg Support
CAUTION: To avoid injury, keep hands away from
fan blade.
3. Position left leg support as shown.
4. Place lockwasher and flat washer on hex screw and
insert through the holes in the support leg and secure to
the threaded holes in the filtration housing as shown.
5. Secure hex screws with adjustable wrench.
Mounting Leg Bracket
1. From the loose parts bag find the following:
4 Flat washers, 5/16 x 11/16 x 1/16)
4 Hex Screws*, M8 x 1.25-12
2. Find the following:
1 Leg Bracket
3. Insert leg bracket between the support legs and slide
against the angled flange of the leg.
NOTE: Make sure holes in leg bracket align with holes on
leg support.
4. Place Flat washer on hex screw, insert through angled
flange of leg support and attach to threaded hole of
bracket.
Hex Head Screw
M8 x 1.25-12
Lockwasher
5/16
Flat Washer
5/16 x 11/16 x 1/16
Guard must point to
rear of machine
Inlet Guard
Hex Screw
Lockwasher
Flat Washer
Filtration Housing
(Upside Down)
“O” Ring
Hex Head Screw
M8 x 1.25-12
Lockwasher
5/16
Flat Washer
5/16 x 11/16 x 1/16
Leg Support
Flat Washer
Hex Screw
Hex Screw
Lockwasher
Flat Washer
Impeller
Motor
Leg Bracket
Blocks of Wood
5. Repeat steps 2 and 3 using same process on other
three holes.