Specifications

4
Introduction
The RIDGID Dust Collection System is specifically
designed to capture sawdust and wood chips at the
source. The fine dust is filtered by the upper bag while
heavy particles settle in the lower bag for easy removal.
Do not use as a vacuum.
CAUTION: The blower housing contains a high
speed fan blade that can amputate fingers, grab
loose clothing and neckties, or propel dust at high
velocities. DO NOT OPERATE WITHOUT ALL
PARTS IN PLACE.
Do not attempt to clean, remove dust bags or service unit
while in operation. Disconnect from power source. This
Dust Collection System is intended for either commercial
or household use.
IMPORTANT NOTE
Please Read Carefully
Static Shocks Are Common - in dry areas or when the
relative humidity of the air is low. To reduce the frequency
of static shocks in your home, the best remedy is to add
moisture to the air with a console or installed humidifier.
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
WARNING: To reduce the risk of electrical hazards,
fire hazards or damage to the tool, use proper cir-
cuit protection. Your tool is wired at the factory for
operation using the voltage shown. Connect tool
to a power line with the appropriate voltage and a
15-amp branch circuit. Use a 15-amp time delay
type fuse or circuit breaker. To reduce the risk of
shock or fire, if power cord is worn or cut, or dam-
aged in any way, have it replaced immediately.
The A-C motor used on this tool is an induction nonrevers-
ible type, having the following specifications:
General Electrical Connections
DANGER: To reduce the risk of electrocution:
1. Use only identical replacement parts when ser-
vicing. Servicing should be performed by a
qualified service technician.
2. Do not use in rain or where floor is wet.
This tool is intended for indoor residential use
only.
WARNING: Do not permit fingers to touch the ter-
minals of plug when installing or removing the
plug to or from the outlet.
110-120 Volt, 60 Hz. Tool Information
NOTE: The plug supplied on your tool may not fit into the
outlet you are planning to use. Your local electrical code
may require slightly different power cord plug connec-
tions. If these differences exist refer to and make the
proper adjustments per your local code before your tool is
plugged in and turned on.
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped
with an electric cord having an equipment grounding con-
ductor and a grounding plug, as shown. The plug must be
plugged into a matching outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
A temporary adapter may be used to connect this plug to
a 2-prong outlet, as shown, if a properly grounded three
prong outlet is not available. This temporary adapter
should be used only until a properly grounded three
prong outlet can be installed by a qualified electrician.
The green colored rigid ear, lug and the like, extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet box.
NOTE: In Canada the use of a temporary adapter is not
permitted by the Canadian electrical code.
Improper connection of the equipment grounding con-
ductor can result in a risk of electric shock. The conduc-
tor with insulation having an outer surface that is green
with or without yellow stripes is the equipment grounding
conductor. If repair or replacement of the electric cord or
plug is necessary, do not connect the equipment-ground-
ing conductor to a live terminal.
Horsepower 1/2
Voltage 110-120
Amperes 8.2
Hertz (Cycles) 60
Phase Single
RPM 1725
Rotation of Shaft Clockwise