Specifications

Maintenance

WARNING: For your own safety, turn switch “OFF”

and remove plug from power source outlet before

maintaining or lubricating your sawdust collection

system.

WARNING: To reduce the risk of injury from electric

shock or suddenly starting unit, always remove

switch key and keep unplugged while unit is disas-

sembled in any way. Always reassemble with rec-

ommended parts before plugging unit in.

Chip Collecting Bag Removal

1. Push band up and slide opposite edge to the middle

opening.

2. Lower band carefully through opening as shown.

Deposit chips in appropriate container.

CAUTION: Wear safety goggles ANSI Z87.1 (or in

Canada CSA Z94-3-M88) to protect your eyes prior

to commencing operation.

3. Reconnect the chip collecting bag by sliding the band

through the hole and slide the opposite side under dust

chute extension. Seat as shown.

Filter/Dust Bag Removal

CAUTION: If using this dust collection system to

help keep airborne wood dust in heavy usage

within acceptable limits, you must regularly moni-

tor airborne dust and maintain dust collection sys-

tem to avoid exceeding dust limits. Each

application is unique. Your maintenance schedule

must, therefore, be tailored to your specific use of

this dust collection system.

1. Shake the filter/dust bag so the fine dust falls into lower

chip collecting bag.

2. Disconnect the adjustable band clamp by releasing the

spring lever clamp.

3. Remove the filter/dust bag and deposit all fine dust in

an appropriate container.

4. Reconnect the bag carefully so the clamp wraps

around the bag on all sides. Adjust the lever to the

fourth hook and fasten securely.

Chip Bag

Adjustable

Band Clamp

Dust Bag

Holder