Specifications

12
Operation
WARNING: To reduce the risk of fire or explosion, do not operate this dust collection system in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or vapors include but are not limited
to; lighter fluid, solvent type cleaners, oil-base paints, gasoline, alcohol or aerosol sprays. Explosive dusts
include but are not limited to; coal, magnesium, grain or gun powder. Do not vacuum explosive dust, flam-
mable or combustible liquids or hot ashes. To reduce the risk of health hazards from vapors or dusts, do not
vacuum toxic materials. To reduce the risk of electric shock, do not expose to rain. Store indoors. To reduce
the risk of injury from accidental starting, unplug power cord before changing, cleaning or emptying filter/
dust bag or chip bag.
This dust collection system is designed to be connected
directly to the woodworking machines. Please, use only
the parts provided for maximum efficiency.
4" Diameter x 60" Hose. PVC vulcanized rubber with wire
reinforcement and 2-4" clamps.
4"/2-1/2" Diameter Adapter. This connector allows direct
hookup to many machines including band saws, belt and
disc sanders and radial saw sawdust collector.
Attaching Accessories to Inlet Guard
4" Diameter hose/clamp assembly and adapter.
1. Lift lever to open over-center clamp. Place clamp over
end of hose. Slide hose/clamp over inlet-guard. Push
lever on clamp to tighten clamp onto inlet-guard. Use
same process to connect adaptor to other end of hose.
CAUTION: To reduce the risk of fire, use only the
hose and adaptor designed for this unit. The adap-
tor is designed to fit only to the hose. Do not attach
it directly to any other inlet opening.
Connecting Dust Collection System to
Power Source
CAUTION: If connected to a circuit protected by
fuses, use time delay fuses with this appliance.
1. Prior to connecting your dust collection system to any
power source, be sure your bags are installed properly.
This will remove any possibility of dust flying in your
face.
2. The motor on your dust collection system is wired for
120 volts, single phase power system. Make sure the
motor rating agrees with the electrical system it is to be
connected to.
3. Too many machines on one circuit will blow fuses. Be
careful not to overload circuit.
Inlet Guard
Clamp
Hose
Clamp
Adapter
Over-Center
Clamp