Specifications

Chip Bag Assembly - Lower Filtration Hous-

ing

1. Insert lower chip bag by tilting the metal reinforced

band at an angle and position it through the hole in the

lower filtration housing.

2. Tuck one side of the band under the sawdust chute

extension.

3. Allow the opposite side to rest on the ridge of the

opening.

4. Tug on the chip bag to insure proper seating.

Upper Filter/Dust Bag Assembly

1. Disconnect the adjustable band clamp and insert the

end through the loops provided at the opening of the

filter/dust bag.

2. Invert the filter/dust bag and slip the open end of the

bag over the 1" relief on the top opening of the filtration

housing.

3. Secure the bag by adjusting the rectangular bar to the

fourth set of hooks.

4. Pull the lever tight until it seats itself.

CAUTION: Make sure the opening of the bag is tight

against the relief so dust will not escape.

Filtration Housing

Sawdust Chute

Extension

Metal

Reinforced

Ring

Chip Bag

Filter/Dust

Bag Holder

Handle

Relief

Filter/Dust

Bag

Adjustable

Band Clamp