Specifications

54
Work Feed Devices (continued)
Fence Extension
When ripping sheets of thin material such
as 1/8" hard board or similar material in
excess of 24" wide, install the fence
extension to support the edge of the work
and prevent material from sliding under
rip fence.
Making the base:
• Start with a piece of 3/4" plywood at
least 4" wide and at least 27" long.
• Cut the base to size as shown.
Making the side:
• Start with a piece of 1/2" plywood at
least 3-1/2" wide and 27" long.
• Cut the side to size as shown.
Putting it together:
• Drill holes in side as shown.
• Put the pieces together as shown.
• Install four wood screws in lower holes.
Install extension:
• Place the extension on the rip fence as
shown with the side against the outside
of the fence and the bottom extending
under the fence.
• Install four bolts in upper 3/8" dia. holes
as shown.
At Least
4"
3/4" Thick Plywood
Base
26-7/8"
26-7/8"
Side
3-1/2"
3/8"
1"
3/8"
1-3/8"
Screw Pilot
Hole
8-1/4"8-1/4" 8-1/4"
Dia.
Base
Side
Rip Fence Right
Workpiece