Specifications

40
Securing Electrical Cords
1. From the bag labeled “Large Parts” find
the following:
3 Wire Ties
Switch Mounted on Right Side
Route motor cord and power cord along
right side of cabinet. Use a hammer to
lightly tap the pointed tabs on the wire ties
into the two holes provided on the right
side of cabinet. Secure both cords in wire
ties.Loop motor cord in rear wire tie to
remove excess slack.
NOTE: One wire tie is extra.
Switch Mounted on Left Side
Route motor cord and power cord along
left side of cabinet. Use a hammer to
lightly tap the pointed tabs on the wire ties
into the three holes provided on the left
side of the cabinet. Secure both cords
through wire ties.
Installing Guide Bar End Caps
1. The left and right end caps for front
guide bar can be installed at this time.
Align the plastic end cap to match pro-
file of bar.
2. Install self tapping 8-32 pan head screw
into each hole.
3. The left and right end caps for rear
guide bar can be installed at this time.
4. Install rear end caps as shown.
NOTE: This completes the assembly of
your table saw. Do not throw away any
remaining hardware until you have read
the entire owners manual.
Wire Tie
Wire Tie
Two Cords
Front End
8 x 1/2 Ty “AB”
Cap
Rear End
Cap
Pan Head Screw
Assembly (continued)
Mounting Switch on Right Side
1. Slide the nuts into the lower slot of the
front guide bar from the right end, with
the switch facing front.
2. Slide switch assembly left until the left
side of switch assembly is in line with
right side of main saw table - tighten
screws.
Mounting Switch on Left Side
1.Slide the nuts into the lower slot of the
front guide bar from the left end, run-
ning wire behind unit, with switch facing
front.
1.Slide the assembly right until the right
side of the switch assembly is in line
with the left side of the main saw table -
tighten screws.