Specifications

20
Assembly (continued)
Assembling Table Extensions
1. From the bag labeled “Table Exten-
sions” remove the following hardware:
(Quantity indicated is for two exten-
sions)
8 Hex Head Screws, 5/16-18 x 1-1/4"
Long
8 Flat Washers, 11/32 x 11/16 x 1/16
8 Lockwashers, 5/16" External Type
8 Hex Nuts, 5/16-18
NOTE: Assemble with saw upside down.
WARNING: Stock table exten-
sions must be installed. They
help support the fence guide
bars. An unsupported guide bar
can twist. Twisted guide bars can
misalign fence. A misaligned
fence can cause binding or kick-
back. You could be hit or cut.
2. Insert four (4) 5/16-18 x 1 in. long screws
through the holes in each extension.
3. Position extension against table so
screws extend through hole in table.
4. Install flat washers, lockwasher, and
nuts on the screws. With a 1/2" wrench,
snug the four nuts just enough to take
the play out between the table and
extension. Do not tighten.
5. Repeat steps 1-4 to install the other
extension.
6. Stand saw upright on legs. Roll saw
over onto front then up onto feet.
WARNING: The saw is heavy. To
reduce the risk of back injury, get
help to lift the saw. Hold the saw
close to your body. Bend your
knees so you can lift with your
legs, not your back.
7. Line up the front edge of extension with
the front edge of the table. At the spots
marked “X” in the drawing, tighten a “C”
Clamp over the edge of table and
extension. Use a combination square to
check the alignment of the front and top
edges nearest the “X”’s. Tighten the
two corner nuts only with a 1/2" wrench.
5/16-18
Hex Nut
5/16 In External
Lockwasher
11/32 I.D.
Flat Washer
5/16-18 x 1-1/4 In
Hex Head Screw
Lockwasher
Flat Washer
Nut
Hex
Screw
Align Front Edges
“C” Clamps
NOTE: This assembly may also be done
without the use of a “C” Clamp.