User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 19011099

Mustang II Front CoolRide Kit

For Use w/ Factory Lower Arms

Components:

2 90006781 Double convoluted airspring – 6.5” diameter, ¼” port

2 90000020 Upper cup bracket (2” tall)

2 90000006 Lower bracket

Hardware Kit:

2 99371001 3/8” x 3/4" USS bolt

4 99371004 3/8” x 1 ¼” USS bolt

8 99372002 3/8” USS Nylok nut

14 99373003 3/8” SAE flat washer

2 99373005 3/8” lock washer

2 99435004 7/16” x 4 ½” stud

2 99432001 7/16” Nylok nut

2 99433002 7/16” SAE flat washer

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 19011099 Mustang II Front CoolRide Kit For Use w/ Factory Lower Arms Components: 2 90006781 Double convoluted airspring – 6.
PAGE 2
SUPPLEMENT FOR MUSTANG II FRONT END With aftermarket crossmember designed for coilsprings [hat type upper mount] Mustang II using OEM lower control arm 1. If you have the OEM Ford lower a-arm, install the u shaped bracket onto the a-arm using the old shock bolt to secure the bracket. 2. The upper bracket is attached through the old shock hole. Note that the airspring mounting holes are offset . This offset should go to the outside. [towards the spindle] 3. Drill a hole in the upper hat to route the airline.