User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 19010600

Mustang II Front Black Series Shock Kit

For Use w/ CoolRide & Lower StrongArm

Components:

2 20000009 Black Series shocks – Eye/Eye

2 90001966 Shock sleeve

2 90000011 Weld-on upper shock bracket

2 90001618 Lower shock stud - .5” O.D.

Hardware:

4 99501003 ½” x 2 ½” USS bolt Shock to upper bracket

4 99502001 ½” USS Nylok nut Shock to upper bracket

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 19010600 Mustang II Front Black Series Shock Kit For Use w/ CoolRide & Lower StrongArm Components: 2 20000009 Black Series shocks – Eye/Eye 2 90001966 Shock sleeve 2 90000011 Weld-on upper shock bracket 2 90001618 Lower shock stud - .5” O.D.
PAGE 2
Installation Instructions 1. The upper shock mount must be welded to the frame. It may need to be cut down to match the stroke of the air spring and suspension. Make sure that when the suspension is fully compressed that the shock is about ¼” from being fully compressed. 2. Tack weld the mount during initial fitment. The lower mount will be installed to the back side of the lower control arm. 3. Check to make sure the shock does not bottom out when the suspension is fully compressed.