User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 12103510

67-70 Mustang Front SA CoilOvers

For Use w/ Upper StrongArms

Shock Assembly:

2 24129999 2.6” Stroke single adjustable shock

2 90009988 2” threaded stud top

2 90001628 .5” I.D. bearing

4 90001995 bearing snap ring

Components:

2 59080700 Coil spring – 8” long / 700 # rate

2 90002312 2” stud top base

2 90002222 Spring retainer kit (included upper and lower spring retainer, screw & clip)

2 90001902 Aluminum cap for Delrin ball

2 90001903 Delrin ball upper half

2 90001904 Delrin ball lower half

4 70010828 Delrin Spring Washer

2 90002356 Upper Shockwave mount

2 90000506 Aluminum Upper plate

Hardware:

2 99562003 9/16” SAE Nylok jam nut Stud top hardware

6 99311012 5/16” x 1” USS Flange bolts Upper mount to strut tower

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 12103510 67-70 Mustang Front SA CoilOvers For Use w/ Upper StrongArms Shock Assembly: 2 24129999 2.6” Stroke single adjustable shock 2 90009988 2” threaded stud top 2 90001628 .5” I.D.
PAGE 2
1. Impact Forged, Monotube shock 2. Rebound adjustment knob (SA Only) 3. Upper coil spring retainer 4. Lower coil spring retainer 5. High tensile coil spring 6. Set screw 7. Delrin Spring Washer 1. Stud top base 2. Lower Delrin ball half 3. Upper Delrin ball half 4. Aluminum cap 5. 9/16” Nylok jam nut 6. Threaded stud 7. Adjustment knob (SA Only) 8. Screw 9.
PAGE 3
1. Place the upper plate on top of the strut tower. While holding the upper Shockwave mount up to the bottom of the strut tower, fasten the assembly with three 5/16” x 1” flange bolts. 2. Place the stud up through the upper mount. (See diagram) 3. Attach the bottom of the shock to the upper arm w/ the hardware supplied w/ the upper arm.
PAGE 4