Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11371099

88-98 Chevy C-1500 Front CoolRide

For Use w/ Factory Lower Arms

Components:

2 90006873 8” diameter double convoluted air springs

2 90000024 Upper air spring cup bracket (Tall)

2 90000057 Lower air spring cup bracket (Short)

2 90001083 Medium bump stops w/ hardware

Hardware:

2 99435002 7/16” x 8” stud Upper cup to frame

2 99432001 7/16” USS Nylok nut Upper cup to frame

2 99433002 7/16” SAE flat washer Upper cup to frame

2 99371001 3/8 x ¾ USS bolt Air spring to lower bracket

4 99372002 3/8” USS Nylok nut Air spring mounting

6 99373003 3/8” SAE flat washer Air spring mounting

2 99373005 3/8” lock washer Air spring to lower cup

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
88-98 Chevy C-1500 Installation Instructions *** Must Use RideTech Front Shock Kit *** 1. Apply thread sealant to the air fitting and screw it into the air spring. Assemble the upper cup bracket to the air spring, using 3/8” Nylok nuts and flat washers. Thread the 8” stud into nut welded to the bottom of the cup. Bolt the lower cup to the bottom of the air spring using a 3/8” x 3/4" bolt, flat washer and lock washer. 2.
PAGE 3
4. Make sure the air spring does not rub on anything through full suspension travel. This will damage the air spring and is not a warrantable situation. Although it is acceptable to allow it to touch the lower control arm when fully deflated. 5. The final step is to have the vehicle realigned. You will want to have this done at ride height. Ride height is determined by air spring height. This spring should be approximately 4 ¾” tall, which should occur around 85-100 psi.