User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11369100

63-87 C-10 Front MuscleBar

For use with StrongArms only

Components:

1 90000664 Sway bar (includes the following)

2 Polyurethane frame bushing

2 Frame bushing bracket

2 90000921 12mm 90 degree PosiLink

2 90000922 12mm straight PosiLink

2 99125001 12mm x 1 ¾” all thread to attach swivel end links (use Loctite)

Hardware Kit: 99010050

4 99122001 12mm Nylok Jam nuts for swivel end links

8 99433002 7/16” flat washers for end links

4 99371004 3/8” x 1 ¼” USS bolt for frame bracket

4 99372002 3/8” USS Nylok nut

8 99373003 3/8” SAE flat washer

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
11369100 Installation Instructions 1. This sway bar is designed for use with RideTech lower StrongArms. It will not work with other arms without modification. 2. Remove the factory sway bar. On trucks with a factory sway bar you will have to remove the sway bar frame mount. 3. For 73-87 Bolt the new MuscleBar to the frame rail using the poly bushing and bracket. The rear hole for the factory sway bar mount will be reused for the rear hole in the new bracket. The front hole must be drilled with a 3/8” bit.
PAGE 3
4. Install the end link to the sway bar and lower arm as shown in the picture. It will be fastened with 12mm jam nuts and flat washers.