User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part #11363699

73-87 C-10 Front Upper StrongArms

Components:

1 90000508 Driver side upper arm

1 90000509 Passenger side upper arm

2 90000721 Cross shaft

2 90000920 Cross shaft kit – 2 bushings per kit

2 90000910 Ball joint (includes boot, grease fitting, castle nut & cotter pin)

Hardware:

4 99753002 ¾” flat washer (2” diameter) Cross shaft

4 99752005 ¾”-16 locking nut Cross shaft

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Drop the ball joint down through the upper control arm plate. Fasten to the arm w/ the hardware supplied. 2. Fasten control arm to frame using the stock hardware. Reuse the alignment shims; however the truck must be realigned after installation. 3. Slide the ball joint boot over the stud, then insert stud through spindle. Secure w/ new castle nut and cotter pin supplied. 4. With the suspension at mid travel, the upper cross shaft nuts can be tightened. 5.
PAGE 3
Item # 1. 1. 2. 3. 4. 5. 6. 7. 8. 9. Description Passenger side arm Driver side arm Cross shaft Cross shaft bushing Ball joint 3/4" x 2” flat washer 3/4"-16 locking nut 5/16”-24 x 1” hex bolt 5/16” lock washer 5/16”-24 hex nut Qty.