User Manual

Part # 11330600

63-72 C-10 Black Series Front Shock Kit

For Use w/ Lower StrongArms

Components:

2 20000011 Shock absorbers – Eye/Stud

2 Hardware kit for 20000011

2 90001619 Cantilever pin w/ hardware

2 90000471 Aluminum spacer

1 90000653 Driver side upper shock bracket – bolt-on

1 90000654 Passenger side upper shock bracket – bolt-on

Hardware:

8 99371004 3/8” x 1 ¼” USS bolt Upper shock bracket to frame

8 99372002 3/8” USS Nylok nut Upper shock bracket to frame

16 99373003 3/8” SAE flat washer Upper shock bracket to frame

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Place the new upper shock mount against the frame, the tab in the front of the bracket will slide into the factory shock stud hole. Position the bracket so that the bottom of the bracket is parallel to the bottom of the frame. Using the bracket as a template, mark an drill four 3/8” holes in the frame rail. Secure the bracket to the frame using four 3/8” x 1 ¼” bolts, Nylok nuts and flat washers. 2.