User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11326699

78-88 GM “G” Body Rear Upper StrongArms

Components:

2 90001118 Upper StrongArm (Set to 11.125”)

2 90001589 Kevlar lined Heim end

4 90002065 Aluminum spacers for Heim end

Hardware:

2 99752004 ¾” SAE Jam nut Heim end

4 99501006 ½” x 3 ½” USS Gr. 8 bolt StrongArms

4 99502001 ½” USS Gr. 8 Nut StrongArms

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11326699 78-88 GM “G” Body Rear Upper StrongArms Components: 2 90001118 Upper StrongArm (Set to 11.125”) 2 90001589 Kevlar lined Heim end 4 90002065 Aluminum spacers for Heim end Hardware: 2 99752004 ¾” SAE Jam nut Heim end 4 99501006 ½” x 3 ½” USS Gr. 8 bolt StrongArms 4 99502001 ½” USS Gr.
PAGE 2
Installation Instructions 1. The length of the upper bar should be set from the factory at 11.125” center to center. Ensure that the jam nut is tight. 2. Using the factory hardware, fasten the heim end to the frame bracket. An aluminum spacer must be installed on each side of the Heim end. 3. Fasten the other end of the bar to the axle using the factory hardware. Note: Inspect the rubber bushing in the axle for wear or cracked. Replace with factory replacement bushing if needed.