Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11322899

78-88 GM “G” Body Lower StrongArms

For Use w/ Shockwaves or CoilOvers

Components:

1 90000657 Driver side lower arm

1 90000658 Passenger side lower arm

2 90000896 Ball joint

2 90000572 Inner bushing sleeve

2 90000573 Inner bushing sleeve

4 90001085 Poly bushing half

4 90001089 Poly bushing half

4 90002062 Aluminum spacer – Shock to lower arm

4 99250001 ¼”-28 grease fitting – Use Lithium grease on frame bushings

Hardware:

2 99501024 ½”-13 x 3 ¼” Gr.5 bolt Shockwave to lower arm

2 99502001 ½”-13 Nylok nut Shockwave to lower arm

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. After removing the factory lower control arm, clean the bushing mounting surfaces on the frame and lubricate with lithium grease. 2. Fasten the lower arm to the frame with the factory hardware. 3. Swing the lower StrongArm up to the shock and secure with the ½” x 3 ¼” bolt and Nylok nut, an aluminum spacer must be installed on each side of the bearing. 4. Slide the ball joint boot over the stud, then push the stud up through the spindle.
PAGE 3
Item # 1. 2. 3. 4. 5. 6. 7. 8. 9. Description Driver side arm Ball Joint Inner bushing sleeve – narrow Inner bushing sleeve – wide Poly bushing half – wide Poly bushing half – narrow Aluminum bearing spacer 1/2”-13 x 3 ¼” bolt ½”-13 Nylok nut Qty.