User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11296698

65-66 Impala Rear Upper StrongArm

Upper Arm Components:

1 90001114 Upper StrongArm – C-C 12.8125”

1 90001589 Kevlar lined Heim end - .75” thread x .625” I.D.

1 99752004 3/4”-16 SAE jam nut

2 90002066 Aluminum bearing spacer

1 90001085 Poly busing half

1 90001089 Poly busing half

1 90000722 Inner bushing sleeve - 2.625" long x .625" I.D x .75" O.D.

Hardware:

2 99621006 5/8” x 3 ¾” SAE Gr. 8 bolt Upper arm

2 99622006 5/8” SAE Nylok jam nut Upper arm

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11296698 65-66 Impala Rear Upper StrongArm Upper Arm Components: 1 90001114 Upper StrongArm – C-C 12.8125” 1 90001589 Kevlar lined Heim end - .75” thread x .625” I.D. 1 99752004 3/4”-16 SAE jam nut 2 90002066 Aluminum bearing spacer 1 90001085 Poly busing half 1 90001089 Poly busing half 1 90000722 Inner bushing sleeve - 2.625" long x .625" I.D x .75" O.D.
PAGE 2
Installation Instuctions 1. Replace the factory upper trailing arm with the StrongArms. 5/8” x 3 ¾” bolts and Nylok jam nuts are supplied to replace the factory hardware. An aluminum spacer will be installed on each side of the Heim end. Note: Some cars may have two upper arms.