Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11289000

65-70 Impala Panhard Bar Kit

Components:

1 90000998 Panhard bar – TW 33.875” (C-C 35.75”)

1 90001942 Rubber bushing – Pressed into panhard bar

1 90001946 Kevlar lined Heim end - .75” thread x .75” I.D.

1 99752004 3/4”-16 SAE jam nut

2 90000724 Aluminum T-bushing

1 90000461 Panhard bar axle stud

Hardware:

1 99622006 5/8” SAE Nylok jam nut Panhard bar stud

1 99561003 9/16” x 3” SAE Gr. 8 bolt Panhard bar to frame

2 99562001 9/16” SAE Nylok jam nut Panhard bar

1 99563001 9/16” USS flat washer Panhard bar stud

1 99603003 5/8” USS flat washer Panhard bar stud

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11289000 65-70 Impala Panhard Bar Kit Components: 1 90000998 Panhard bar – TW 33.875” (C-C 35.75”) 1 90001942 Rubber bushing – Pressed into panhard bar 1 90001946 Kevlar lined Heim end - .75” thread x .75” I.D.
PAGE 2
Installation Instuctions 1. Replace the factory panhard bar with the new one using the new stud and hardware supplied. The rubber rod end will be attached to the axle. 2. The Heim end will attach to the frame using the 9/16” x 3” bolt and Nylok nut. Two aluminum Tbushings need to be installed on each side of the Heim end. 3. The panhard bar should be approximately 35 ¾” center eye to center eye, but may need adjusted to center the axle. This should be checked at ride height.