Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11283699

65-70 Impala Front Upper StrongArms

Components:

1 90000478 Driver side upper arm

1 90000479 Passenger side upper arm

2 90000905 Ball joint (includes boot, grease fitting, castle nut & cotter pin)

2 90000907 Bushing kit (4 pieces)

2 90000102 Cross shaft

Hardware:

4 99373005 3/8” Lock washer Upper cross shaft

4 99371013 3/8” x 1” SAE bolt Upper cross shaft

4 99373001 3/8” fender washer Upper cross shaft

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Drop the ball joint down through the ball joint plate, secure w/ the hardware supplied. 2. Fasten the upper arm to the frame using the factory hardware. Reinstall the current alignment shims, but vehicle must be realigned. This arm was designed with an extra 2 degrees of positive caster allowing the car to be aligned with up to 4 degrees of positive caster. (This will vary from car to car.) Driver Side – Top View 3.
PAGE 3
Item # 1. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Description Passenger side arm Driver side arm Cross shaft Cross shaft bushing Ball joint 5/16”-24 x 1” hex bolt 5/16”-24 hex nut 5/16” lock washer 3/8”-24 x 1” hex bolt 3/8” lock washer 3/8” x 1.5” flat washer Qty.