Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11281099

65-70 Impala Front CoolRide Kit

Components:

2 90006781 255c air spring

2 90000052 Upper air spring cup bracket (4.5” tall)

1 90000408 Lower air spring plate with shock mount

1 90000409 Lower air spring plate with shock mount

Hardware:

2 99435002 7/16” x 8” stud Upper cup bracket to frame

2 99432001 7/16” USS Nylok nut Upper cup bracket to frame

2 99433002 7/16” flat washer Upper cup bracket to frame

8 99372002 3/8” USS Nylok nut Air spring to cup & lower plate to control arm

4 99371004 3/8” x 1 ¼” uss bolt Lower air spring plate to control arm

2 99371001 3/8” x 3/4" USS bolt Air spring to lower plate

14 99373003 3/8” SAE flat washer Air spring plate

2 99373005 3/8” lock washer Air spring to lower plate

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11281099 65-70 Impala Front CoolRide Kit Components: 2 90006781 255c air spring 2 90000052 Upper air spring cup bracket (4.
PAGE 2
Installation Instructions *****For use w/ RideTech front shock kit***** 1. Place the lower air spring plate onto the lower control arm as shown in the picture. This is the Drivers side with the shock mount to the rear of the control arm. The plate will index off the rear strut arm bolt. The other two holes must be drilled for 3/8” x 1 1/4" bolts. Install flat washers and Nylok nuts. 2. The coil spring pocket will need to be trimmed for air spring clearance as shown in the picture. 3.
PAGE 3
6. Install the air spring assembly into the coil spring pocket with the all thread protruding through the factory shock hole. The fitting access hole will be clocked towards the outer tie rod end. Fasten with 7/16” Nylok and flat washer. The airline must be routed at this time. 7. Secure the air spring to the lower plate use a 3/8” x 3/4" bolt, lock washer, and flat washer. 8. Place a jack under the control arm and fully compress the air spring to double check air spring clearance. 9.