User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11280701

65-70 Impala HQ Series Rear Shock Kit

Components:

2 24179999 7” stroke HQ Series shock

2 90002024 1.7” eyelet – Adjustable

4 90001994 .625” bearing

8 90001995 Snap ring for bearing

2 90002010 Extended T-bar – Installed in shock body

4 90001980 Snap ring for T-bar

4 90002067 Aluminum bearing spacer - .625” I.D.

2 90001619 Round head cantilever pin

2 90000471 Aluminum spacer

Hardware:

4 99371004 3/8” x 1 ¼” USS bolt Shock to frame

8 99373003 3/8” SAE flat washer Shock to frame

4 99372002 3/8” USS Nylok nut Shock to frame

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11280701 65-70 Impala HQ Series Rear Shock Kit Components: 2 24179999 7” stroke HQ Series shock 2 90002024 1.7” eyelet – Adjustable 4 90001994 .625” bearing 8 90001995 Snap ring for bearing 2 90002010 Extended T-bar – Installed in shock body 4 90001980 Snap ring for T-bar 4 90002067 Aluminum bearing spacer - .625” I.D.
PAGE 2
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Installation Instructions 1. Fasten the upper shock T-bar to the bottom of the frame using two 5/16” x 1” bolts, Nylok nuts and flat washers. 2. Use the new cantilever pin supplied to attach the bottom of the shock to the axle. 1. Cantilever Pin 2. 5/8” SAE Washer 3. Aluminum Bearing Spacer 4. .625” Bearing 5. Aluminum Bearing Spacer 6. Factory axle bracket 7. ½” Lock Washer 8.