Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11239100

64-67 GM “A” Body Front MuscleBar

Components:

1 90000156 Front sway bar (37.875”)

1 90000148 Driver side arm

1 90000149 Passenger side arm

2 90000152 Frame plate

2 90000150 Frame bracket

2 90000926 90 degree 10mm PosiLink

2 90000924 Straight 10mm PosiLink

4 90000717 T-bushing (PosiLink to lower arm)

2 90001099 Polyurethane frame bushing - 1.5” I.D.

2 99250001 ¼” - 28 straight grease zerk

1 90001092 Tube of Lithium grease

2 99115001 10mm x 1.5 x 36mm stud (use Loctite) In PosiLink

Hardware Kit: 99010040

2 99371028 3/8” x 3/4" USS Flat head Allen bolt Frame plate to frame

4 99371004 3/8” x 1 ¼” USS bolt Frame bracket

14 99373003 3/8” SAE flat washer Frame bracket / Sway bar arm to bar

10 99373005 3/8” lock washer Frame bracket / Sway bar arm to bar

6 99371017 3/8” x 1” Button head Allen bolt Sway bar arm to bar

4 99112002 10mm Nylok nut PosiLink

2 99502003 ½” SAE Nyloc jam nut Steering arm

PDF created with pdfFactory trial version www.pdffactory.com

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11239100 64-67 GM “A” Body Front MuscleBar Components: 1 90000156 Front sway bar (37.875”) 1 90000148 Driver side arm 1 90000149 Passenger side arm 2 90000152 Frame plate 2 90000150 Frame bracket 2 90000926 90 degree 10mm PosiLink 2 90000924 Straight 10mm PosiLink 4 90000717 T-bushing (PosiLink to lower arm) 2 90001099 Polyurethane frame bushing - 1.5” I.D.
PAGE 2
11239100 Installation Instructions 1. This sway bar was designed for use with our lower StrongArms. Installation with other control arms may require modification. 2. Remove the end links from the factory sway bar. Then remove the bolts attaching the sway bar to the frame. 3. Bolt the frame plate to the frame using the factory sway bar holes. The front hole will use a 3/8” x 3/4" flat head Allen screw. The rear hole will use a standard 3/8” x 1 ¼” hex bolt. 4.
PAGE 3
7. Bolt the sway bar arm to the bar using 3/8” x 1” Button head screws with flat washers and lock washers. 8. Fasten the 90 degree end of the PosiLink to the sway bar arm using a 3/8” flat washer on each side of the arm and a 10mm Nylok nut. 9. Two T-bushing will be used on each side to attach the straight end of the PosLink to the lower control arm. Secure with a 10mm Nylok nut. 10. Install the thin ½” Nylok nuts on the front bolt of the steering arm, and cut off excess threads. 11.