User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11224499

64-72 GM “A” Body Rear Lower StrongArms

Components:

2 90001026 Lower StrongArm – WW 22”

8 90001089 Poly bushing half – .75” I.D. x 1.5” O.D. x 1.125” long

4 90000516 Bushing sleeve - .5” I.D. x .75” O.D. x 2.375” long

2 90001092 Tube of Lithium grease – to lubrication bushing mounting surfaces

Hardware:

4 99431003 7/16” x 3” USS bolt Swaybar to lower bars

4 99432001 7/16” USS Nylok nut Swaybar to lower bars

8 99433002 7/16” SAE flat washer Swaybar to lower bars

4 99501006 ½” x 3 ½” USS Gr. 8 bolt StrongArms to frame

4 99502001 ½” USS Gr. 8 Nylok nut StrongArms to frame

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11224499 64-72 GM “A” Body Rear Lower StrongArms Components: 2 90001026 Lower StrongArm – WW 22” 8 90001089 Poly bushing half – .75” I.D. x 1.5” O.D. x 1.125” long 4 90000516 Bushing sleeve - .5” I.D. x .75” O.D. x 2.
PAGE 2
Installation Instructions 1. Remove the sway bar (if equipped) and factory lower trailing arm. Do one side at a time to keep the axle from rotating. 2. Clean bushing mounting surfaces on frame. Lubricate w/ lithium grease supplied. 2. Attach to front on the lower StrongArm to the frame using the ½” x 3 ½” bolts and Nylok nuts supplied. 3. This arm has holes in the tube for sway bar attachment. Mount the bar so that the holes are closest to the axle.