Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11220500

64-72 GM “A” Body Front Black Series Shock Kit

For Use w/ CoolRide

Components:

2 20000009 Black Series shocks – Eye/Eye

2 90001966 Shock sleeve

2 90000011 Weld-on upper shock bracket

2 90000034 Lower shock bracket

Hardware:

4 99501003 ½” x 2 ½” USS bolt Shock to upper bracket

4 99502001 ½” USS Nylok nut Shock to upper bracket

2 99371004 3/8” x 1 ¼” USS bolt Lower bracket to arm

2 99372002 3/8” USS Nylok nut Lower bracket to arm

4 99373003 3/8” SAE flat washer Lower bracket to arm

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. The upper shock mount must be welded to the frame. It may need to be cut down to match the stroke of the air spring and suspension. Make sure that when the suspension is fully compressed that the shock is about ¼” from being fully compressed. 2. Tack weld the mount during initial fitment. The lower mount will be installed right behind the steer stop on the lower control arm. 3. Check to make sure the shock does not bottom out when the suspension is fully compressed.