User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11201099

82-92 Camaro Front CoolRide kit

Components:

2 90006781 Air spring – 6.5” diameter double convoluted

2 90000545 Upper cup bracket

1 90000547 Lower air spring mounting plate (pass. side)

1 90000546 Lower air spring mounting plate (drivers side)

2 31954201 Airline fitting - ¼”npt x ¼” tube 90 degree

Hardware:

2 99435001 6” x 7/16” stud Upper cup mounting

2 99432001 7/16” Nylok nut Upper cup mounting

2 99433002 7/16” SAE flat washer Upper cup mounting

6 99371004 3/8” x 1 1/4” USS bolt Lower mounting plates to a-arm

2 99371001 3/8” x 3/4” USS bolt Lower air spring mounting

18 99373003 3/8” SAE flat washer Air spring mounting

12 99372002 3/8” USS Nylok nut Air spring mounting

2 99373005 3/8” lock washer Lower air spring to plate

2 99371011 3/8” x 6 1/2” USS bolt Sway bar end link

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11201099 82-92 Camaro Front CoolRide kit Components: 2 90006781 Air spring – 6.5” diameter double convoluted 2 90000545 Upper cup bracket 1 90000547 Lower air spring mounting plate (pass.
PAGE 2
Installation Instructions 1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang freely 2. Remove the coil spring and bump stop. Refer to a factory service manual for proper disassembly procedure. 3. The outer lip of the coil spring pocket must be removed for air spring clearance. This is best done with a cut off wheel or plasma cutter. Grind smooth when finished. If the air spring rubs on the frame it will damage the air spring.
PAGE 3
6. Set the air spring plate on the lower control arm. The plate will index off of the factory bump stop hole. Insert a 3/8” x 1 1/4" with Nylok and flat washers. NOTE: There is a driver and passenger side plate; this is the driver. 7. Two more bolts will hold the plate to the lower arm. They are located on the backside of the arm and require a 7/16” hole in the arm. They will also use a 3/8” x 1 1/4" bolt with Nylok and flat washer. 8.