Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11144099

65-70 Buick Fullsize & 66-70 Riviera Rear CoolRide

Components:

2 90009002 Tapered sleeve air spring

2 90000708 Upper air spring cup bracket

2 90000224 Upper washer (Medium)

2 90000291 Lower washer (Small)

2 90000290 Air spring roll plate (Large)

1 90000707 Carrier bearing spacer

Hardware:

2 99435005 7/16” x 3 ¾” stud Upper mount to frame (Cut down to 2 ½”)

2 99432001 7/16” Nylok nut Upper mount to frame

2 99433002 7/16” SAE flat washer Upper mount to frame

4 99371001 3/8” x 3/4" USS bolt Air spring to upper mount

2 99371003 3/8” x 1” USS bolt Air spring to lower mount

6 99373005 3/8” lock washer Air spring

6 99373003 3/8” SAE flat washer Air spring

4 99311002 5/16” x 1 ¼” USS bolt Carrier bearing

4 99312003 5/16” USS Nylok nut Carrier bearing

8 99313002 5/16” SAE flat washer Carrier bearing

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Raise the vehicle to a safe and comfortable working height with the suspension hanging freely. 2. Remove the factory shock absorbers and coil spring. Refer to a factory service manual for proper disassembly procedures. *** Must Use RideTech Shock Kit *** 3. To allow the lower piston of the air spring to seat down into the coil spring retainer, the top of the retainer must be trimmed off. 4. Apply thread sealant an elbow air fitting and screw it into the top of air spring. 5.
PAGE 3
7. Replace the factory shocks with the new ones supplied. 8. To correct the drive line angle we have supplied carrier bearing spacers. These will be installed between the carrier bearing cross member and the frame. 5/16” x 1 ¼” bolts flat washers and Nyloks are also supplied. 9. Ride height on this air spring is approximately 8” tall.