Instruction Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11114099

65-70 Cadillac Rear CoolRide

Components:

2 90002018 Rolling sleeve air spring – 91mm

2 90000243 Upper air spring washer (4.5” O.D.)

2 90000548 Lower air spring roll plate (7.25” O.D. x 2.75” I.D.)

2 90000244 Lower air spring washer

2 90000504 Upper mounting stud

2 90002284 Large cotter pin – Air spring to frame

Hardware:

2 99371004 3/8” x 1 ¼” USS Bolts Air spring to axle

2 99373005 3/8” lock washer Air spring to axle

2 99373003 3/8” SAE flat washer Air spring to axle

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11114099 65-70 Cadillac Rear CoolRide Components: 2 90002018 Rolling sleeve air spring – 91mm 2 90000243 Upper air spring washer (4.5” O.D.) 2 90000548 Lower air spring roll plate (7.25” O.D. x 2.75” I.D.
PAGE 2
Installation Instructions 1. Raise and support vehicle at a safe and comfortable working height. 2. Support the axle then remove coil spring and shock. Refer to service manual for proper disassembly procedure. *** Must Use RideTech Shock Kit *** 3. To allow the air spring to sit flat on top of the axle mount, the coil spring retainer must be cut down to about ¼” tall.
PAGE 3
5. Place the 4.5” diameter washer on top of the coil spring pocket, between the frame and the body. 6. Place the air spring up into the spring pocket inserting the mounting pin through the hole in the upper plate. Secure the assembly with the large cotter pin. 7. Place the 7.25” air spring roll plate over the cut down coil spring retainer. Pull the lower piston down to the plate. 8. Secure the air spring to the axle using the D-shaped plate, 3/8” x 1 ¼” bolt, flat washer and lock washer. 9.