Owner manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11069000

59-64 Chevy Impala Panhard Bar Kit

Components:

1 90000993 Panhard bar

1 90001942 Rubber bushing – pressed into panhard bar

1 90001946 Panhard Kevlar lined Heim end – 3/4" I.D.

2 90000460 Aluminum T bushing – for heim end

1 90001946 Panhard bar rod end

1 90000461 Panhard bar stud

Hardware:

2 99603003 5/8” USS flat washer Panhard bar stud

1 99563001 9/16” USS flat washer Panhard bar stud

1 99561001 9/16” x 2 ½” SAE Gr.8 bolt Panhard bar to frame

2 99562001 9/16” SAE Nylok nut Panhard bar

1 99752004 3/4"-16 Jam nut Heim ends

1 99622006 5/8” SAE Nylok jam nut Pan hard bar stud

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11069000 59-64 Chevy Impala Panhard Bar Kit Components: 1 90000993 Panhard bar 1 90001942 Rubber bushing – pressed into panhard bar 1 90001946 Panhard Kevlar lined Heim end – 3/4" I.D.
PAGE 2
Installation Instructions 1. Install the ¾” jam nut onto the end of the Heim end, then screw Heim end into the end of the panhard bar. 2. Press the aluminum T-bushings into the Heim end. Fasten the Heim end to the frame bracket using the 9/16” x 2 ½” bolt and Nylok nut supplied. 3. Bolt the new panhard bar stud onto the axle in factory stud location using the 9/16” Nylok nut and flat washer supplied. 4.