User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11053699

58-64 Impala Front Upper StrongArms

Components:

1 90000478 Passenger side Upper Arm

1 90000479 Driver side Upper Arm

2 90000905 Ball Joints (includes boot, grease fitting, castle nut & cotter pin)

4 90000907 Cross shaft bushing

2 90000927 Upper Cross Shaft

Hardware:

4 99371014 3/8”-24 x 1 ¼” Gr. 8 bolt Upper cross shaft

4 99373001 3/8” x 1 1/2” washer Upper cross shaft

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11053699 58-64 Impala Front Upper StrongArms Components: 1 90000478 Passenger side Upper Arm 1 90000479 Driver side Upper Arm 2 90000905 Ball Joints (includes boot, grease fitting, castle nut & cotter pin) 4 90000907 Cross shaft bushing 2 90000927 Upper Cross Shaft Hardware: 4 99371014 3/8”-24 x 1 ¼” Gr.
PAGE 2
Installation Instructions 1. Drop the ball joint down through the ball joint plate, secure w/ the hardware supplied. 2. Fasten the upper arm to the frame using the factory hardware. Reinstall the current alignment shims, but vehicle must be realigned. This arm was designed with an extra 2 degrees of positive caster allowing the car to be aligned with up to 4 degrees of positive caster. (This will vary from car to car.) 3.
PAGE 3
Item # 1. 1. 2. 3. 4. 5. 6. 7. 8. 9. Description Passenger side arm Driver side arm Cross shaft bushing Cross shaft Ball joint 5/16”-24 x 1” hex bolt 3/8”-24 x 1 ¼” hex bolt – Gr. 8 3/8” x 1 1/2” washer 5/16” lock washer 5/16”-24 hex nut Qty.