Instruction Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11051499

58-64 Chevy Front Lower StrongArms

For Use w/ CoolRide

Components:

1 90000480 Driver side lower arm

1 90000481 Passenger side arm

2 90000676 Cross shaft

2 90000677 Cross shaft clamp

4 90000906 Cross shaft bushing

1 90000476 Drivers side steering stop

1 90000477 Passenger side steering stop

2 90000904 Ball joint (includes boot, castle nut & cotter pin)

2 99250001 ¼”-20 grease fitting

Hardware:

2 99371011 3/8”-16 x 6 ½” bolt Sway bar end link

2 99372005 3/8”-16 Nylok nut Sway bar end link

4 99311001 5/16”-18 X 1” bolt Steering stop to lower arm

4 99313002 5/16” SAE flat washer Steering stop to lower arm

4 99312003 5/16”-18 Nylok nut Steering stop to lower arm

4 99431004 7/16”-20 x 2” gr. 8 bolt Lower arm cross shaft clamp to frame

4 99431006 7/16”-20 x 1 ¼” gr. 8 bolt Lower arm cross shaft

4 99503004 ½” Fender washer Lower arm cross shaft

8 99433003 7/16” lock washer Lower arm cross shaft & clamp

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions Note: These arms will not work with stock 1958 spindles. 1. Raise and support car at a safe, comfortable working height. Let the front suspension hang freely. 2. Remove coil spring, shock absorber, and lower control arm. Refer to factory service manual for proper disassembly procedure. 3. Bolt the lower StrongArm shaft to the frame. 7/16” x 2” bolts, lock washers and flat washer will be used to fasten the aluminum clamp to the frame. 4.
PAGE 3
58-64 Chevy CoolRide Driver Side Lower Strong Arm Item # 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Description Driver side arm Cross shaft Cross shaft Cross shaft bushing Steering stop bracket Ball joint 5/16”-18 X 1” bolt 5/16” SAE flat washer 5/16”-18 Nylok nut 7/16”-20 x 2” gr. 8 bolt 7/16”-20 x 1 ¼” gr. 8 bolt ½” Fender washer 7/16” lock washer 3/8”-16 x 6 ½” bolt 3/8”-16 Nylok nut Qty.