User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11050702

58-64 Chevy Impala Rear Master Series DA Shock Kit

Components:

2 21269999 6” Stroke Master Series double adjustable shock

2 90001632 Compression bump stop

2 90001901 Master Series 3” eyelet

4 90001686 .625” bearing

4 90001900 Bearing snap ring

2 90002010 Extended T-bar (installed in eyelet)

2 90001980 Snap ring for T-bar

4 90002042 Aluminum spacer for .625” bearing

Hardware:

4 99371004 3/8” x 1 ¼” USS bolt Shock to frame

4 99372002 3/8” USS Nylok nut Shock to frame

8 99373003 3/8” SAE flat washer Shock to frame

2 99502002 ½” SAE Nylok Nut Shock to lower stud

2 99503001 ½” SAE flat washer Shock to lower stud

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11050702 58-64 Chevy Impala Rear Master Series DA Shock Kit Components: 2 21269999 6” Stroke Master Series double adjustable shock 2 90001632 Compression bump stop 2 90001901 Master Series 3” eyelet 4 90001686 .625” bearing 4 90001900 Bearing snap ring 2 90002010 Extended T-bar (installed in eyelet) 2 90001980 Snap ring for T-bar 4 90002042 Aluminum spacer for .
PAGE 2
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com 1. Attach shock T-Bar to frame using 3/8” x 1 ¼” bolts, Nylok nuts and flat washers. 2. Attach the bottom of the shock to factory shock stud using the ½” Nylok nut & flat washer supplied. Install one aluminum spacer on each side of the bearing.
PAGE 3