User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11019100

55-57 Chevy Front MuscleBar

Components:

1 90000731 Sway Bar

2 90001100 Bushing and strap kit

2 90000729 Frame plate

4 90000717 Aluminum step washer

2 90000924 10mm straight PosiLink

2 90000926 10mm 90 degree PosiLink

1 90001092 Tube of lithium grease

2 99115001 10mm x 1.5 stud In PosiLink (use Loctite)

Hardware Kit: 99010047

2 99115006 10mm lock washer 90 degree PosiLink

2 99112002 10mm Nylok nut Straight PosiLink

8 99371005 3/8” x 1 ¼” USS bolt Frame plate

8 99372002 3/8” USS Nylok nut Frame plate

18 99373003 3/8” SAE flat washers Frame plate & PosiLink

PDF created with pdfFactory trial version www.pdffactory.com

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11019100 55-57 Chevy Front MuscleBar Components: 1 90000731 Sway Bar 2 90001100 Bushing and strap kit 2 90000729 Frame plate 4 90000717 Aluminum step washer 2 90000924 10mm straight PosiLink 2 90000926 10mm 90 degree PosiLink 1 90001092 Tube of lithium grease 2 99115001 10mm x 1.
PAGE 2
11019100 Installation Instructions This sway bar is designed for use with Air Ride Technologies StrongArms. 1. The sway bar frame plate will index off of this factory support brace rivet. Remove the rivet by grinding the head smooth, then drive it out with a hammer and punch. 2. Drill hole to 3/8”. 3. Using a 3/8” x 1 ¼” bolt, flat washer and Nylok nut, bolt the frame plate to the bottom of the frame rail. 4. Make sure the side of the plate is aligned with the outside of the frame rail.
PAGE 3
6. Apply lithium grease to the poly bushing. Install the bushing over the sway bar, and then place the bushing strap over the bushing. 7. Bolt the sway bar to the frame plate using two 3/8” x 1 ¼” bolts, Nylok nuts and flat washers. Do not tighten yet. 8. Bolt the 90 degree end of the PosiLink to the sway bar. A 3/8” flat washer and 12mm lock washer must be installed between the PosiLink and the bar. 9. Bolt the straight end of the PosiLink to the lower control arm.