User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part Number 11013699

55-57 Chevy Upper StrongArms

Components:

1 90000541 Driver side upper arm

1 90000542 Passenger side upper arm

2 90000905 Ball joint (includes boot, grease fitting, castle nut & cotter pin)

4 90000907 Cross shaft bushing

4 90000543 Upper cross shaft large sleeve

4 90000544 Upper cross shaft small sleeve

Hardware:

4 99371015 3/8”-24 x 1 ½” bolts Upper cross shaft

4 99373005 3/8” lock washers Upper cross shaft

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Remove the upper control arm and cross shaft. The factory cross shaft will be reused. 2. Place the larger sleeve over the end of the upper cross shaft, slide the cross shaft through the StrongArm. Then press the bushing over the shaft. Insert the smaller sleeve inside the bushing and tighten the assembly with the 3/8”24 x 1 1/2" bolts. 3. Install the ball joint into the upper StrongArm also facing down. 4.
PAGE 3
55-57 Chevy Upper StrongArm Item # 1. 1. 2. 3. 4. 5. Description Passenger side arm Driver side arm Ball Joint Upper Cross shaft Large Sleeve Cross shaft bushing Upper Cross shaft Small Sleeve Qty.