User Manual

ManualsBrandsRidetech ManualsCar11012899

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11012899

55-57 Chevy Car Lower StrongArms

For Use with Shockwaves or CoilOvers

Components:

1 90000561 Driver side lower control arm

1 90000562 Passenger side lower control arm

2 90000916 Lower ball joint (includes boots, castle nuts and cotter pins)

4 90000906 Lower control arm bushing

4 90002062 Aluminum spacers for Shockwaves

Hardware:

2 99501024 ½”-13 x 3 ¼” Gr. 5 bolt ShockWave to lower arm

2 99502001 ½”-13 Nylok nut ShockWave to lower arm

Summary of content (4 pages)

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11012899 55-57 Chevy Car Lower StrongArms For Use with Shockwaves or CoilOvers Components: 1 90000561 Driver side lower control arm 1 90000562 Passenger side lower control arm 2 90000916 Lower ball joint (includes boots, castle nuts and cotter pins) 4 90000906 Lower control arm bushing 4 90002062 Aluminum spacers for Shockwaves Hardware: 2 99501024 ½”-13 x 3 ¼” Gr.
PAGE 2
Installation Instructions 1. Remove factory cross shafts from lower arm and install the factory cross shaft onto the lower StrongArm using the factory hardware. Some grinding must be done on the cross shaft to be able to slide it into the StrongArm. Replacement bushings are provided. Note: There is a driver and passenger side lower cross shaft. The extended length of the shaft should go to the front of the vehicle. 2. Install the ball joints in the lower arm pointing down. 3.
PAGE 3
Driver Side 4. Bolt the Shockwave or CoilOver to the lower arm using the supplied 1/2" x 3 1/4" bolt and Nylok. An aluminum spacer on both sides of the eye will center the Shockwave. Note: There are holes on the lower arm near the ball joint to mount the factory bump stop. Although, it is not needed unless you are having tire clearance issues. 5. Slide the ball joint through the spindle and secure w/ castle nut and cotter pin. 6. Grease the ball joints. 7.
PAGE 4
Item # 1. 1. 2. 3. 4. 5. 6. 7. 8. Description Passenger side arm Driver side arm Aluminum bearing spacer 1/2”-13 x 3 ¼” bolt 1/2"-13 Nylok nut Cross shaft bushing Ball joint 5/16”-24 nut 5/16”-24 x 3/4" bolt Qty.