Operating instructions

32DDO05.A
2
-
6
b. LOWER LIFT PLATFORM - Press and hold the UP/DOWN switch in the DOWN
position until the platform reaches ground level and the outer rollstop opens
completely.
c. Carefully place wheelchair centrally on platform, facing outward, and LOCK
WHEELCHAIR BRAKES. Be certain wheelchair is properly positioned on plat-
form and does not contact outer rollstop and prevent it from locking as the
platform rises.
d. RAISE LIFT PLATFORM - Press and hold the UP/DOWN switch in the UP po-
sition until the platform raises and stops automatically at the vehicle floor
level.
e. STOW LIFT PLATFORM OR RAMP/CLOSE DOORS - Press and hold the DE-
PLOY/STOW switch until the lift platform or ramp fully stows and the doors
close completely.
3. TO EXIT VEHICLE:
a. OPEN DOORS/DEPLOY LIFT PLATFORM OR RAMP - Press and hold control
pendant DEPLOY/STOW switch in the DEPLOY position until the doors open
and the lift platform fully deploys and stops automatically at the vehicle floor
level or the ramp fully deploys.
b. ALWAYS EXIT VEHICLE FACING OUTWARD. Be certain platform is safely at
vehicle floor level and platform rollstop is in an up and locked position.
c. LOWER LIFT PLATFORM - Press and hold the UP/DOWN switch in the DOWN
position until the platform reaches ground level and the outer rollstop opens
completely.
d. Release wheelchair brakes and carefully exit platform.
e. RAISE LIFT PLATFORM - Press and hold the UP/DOWN switch in the UP po-
sition until the platform raises and stops automatically at the vehicle floor
level.
f. STOW LIFT PLATFORM OR RAMP/CLOSE DOORS - Press and hold the DE-
PLOY/STOW switch until the lift platform or ramp fully stows and the doors
close completely.
4. MANUAL OPERATION
In the event the power door operators become inoperable under their own power, they
can be operated manually as follows:
WARNING!
NEVER REMOVE LATCH PIN WHILE VEHICLE IS IN MOTION, AS DOORS CAN
OPEN CREATING A DANGEROUS SITUATION FOR PASSENGERS. NEVER AL-
LOW CHILDREN TO PLAY WITH THE HITCH PIN CLIPS OR LATCH PINS.
— Remove the Hitch Pin Clips located beneath the Clevis Brackets used to secure the
Latch Pin.
— Pull the Latch Pins UPWARD through the Clevis Brackets and Rod Ends and store
in a safe place.
— Push doors open until clear of platform or ramp path.
TO NEXT CHAPTER
BACK TO TABLE OF CONTENTS