Innovation in Mobility RDO2900 Series Internal Power Swing Door Operator PRINT Operator Manual 02/14/02 32DDO05.A 92-2002 RICON CORPORATION All Rights Reserved U.S.
This RICON product must be installed and serviced by authorized RICON service technicians. The operator must refer to this manual for operating instructions, then retain it for future reference. Customer Name: Installing Dealer: Date Installed: Serial Number: 32DDO05.
REVISION RECORD REV PAGES 32DDO05. A All DESCRIPTION OF CHANGE New release, in two-book format. END OF LIST ii 32DDO05.
TABLE OF CONTENTS Chapter: I. Page INTRODUCTION .......................................................................................1-1 A. RICON ONE-YEAR LIMITED WARRANTY ..................................................1-1 B. SHIPMENT INFORMATION .......................................................................1-3 C. GENERAL SAFETY PRECAUTIONS ...........................................................1-3 D. PRODUCT TERMINOLOGY................................................................
TO NEXT CHAPTER iv 32DDO05.
I. INTRODUCTION T he RICON RDO2900 Series Internal Power Swing Door Operators electrically open and close swing-type van doors. They have been designed to operate in most full size vans and provide up to 90° of motion for each door. The power door operators are installed within the doors. Adjustable bell-cranks provide smooth operation, and a splined connection between the crankarm and the motor output shafts provide wobble-free operation. The power door operators work with wheelchair lifts and ramps.
RICON CORPORATION ONE-YEAR LIMITED WARRANTY Ricon Corporation (Ricon) warrants to the original purchaser of this product that Ricon will repair or replace at its option any parts that fail by reason of defective material or workmanship as follows: • Repair or replace parts for a period of one year from date of purchase. A complete list of parts covered can be obtained from a Ricon authorized dealer. If You Need to Return a Product: Return this Ricon product to your installing dealer.
B. SHIPMENT INFORMATION Ricon does not sell directly to the user because of the specialized nature of this product. The product is distributed through a worldwide network of authorized Ricon dealers who perform actual installation. ¡ When the product is received, unpack it and check for freight damage. Claims for any damage should be made to freight carrier immediately. ¡ Be sure installation kit contains all items listed on kit packing list.
D. PRODUCT TERMINOLOGY The references used throughout this manual are illustrated in Figure 1-1 and defined in Table 1-1. Refer to Service Manual, Chapter IV, “Spare Parts” for more details. FIGURE 1-1: RDO2900 SERIES INTERNAL POWER DOOR OPERATOR (FOR RIGHT DOOR) TABLE 1-1: RDO2900 SERIES COMPONENT TERMINOLOGY REF NAME DESCRIPTION 1 Right 2 Left 3 Front 4 Rear 5 Main plate Mounts the door operator assembly to the vehicle door.
II. OPERATING INSTRUCTIONS his chapter contains safety precautions, daily safety check instructions, control and indicator descriptions, and operating instructions for the RICON RDO2900 Series Internal Power Swing Door Operator. This chapter must be read and thoroughly understood by the vehicle operator before attempting to use the power door operator. T A. ¡ SAFETY PRECAUTIONS Refer to Figure 2-1.
B. DAILY SAFETY CHECK Inspect the power door operators prior to each use and check that the following conditions are met before operating: ¡ All functions operate properly. If unusual noises or movements exist, DO NOT use and contact an authorized Ricon service technician for repair. ¡ No objects that may interfere with operation are present. ¡ General appearance and lubrication are satisfactory. ¡ All fasteners are tight. C.
2. ELECTRICAL CONTROLS AND INDICATORS The power door operator electrical controls and indicators are on the top of the wheelchair lift electrical cover. For detailed door operator electrical control and indicator descriptions, refer to the appropriate Ricon lift or ramp service manual.
b. Lift or Ramp Main Circuit Breaker Refer to Figures 2-6 and 2-7. The lift or ramp main circuit breaker is located in the vehicle engine compartment and is designed to interrupt electrical power to the lift or ramp electrical system in case of a short circuit. In the event of a short circuit, the circuit breaker reset tab or button will “pop-down” or “pop-out”. If pressing and releasing the reset tab or button does not reset/ restore power, DO NOT press and hold.
D. POWER DOOR OPERATION WARNING! IMPROPER USE OF THE DOOR OPERATORS CAN RESULT IN PERSONAL INJURY. USERS MUST READ AND FOLLOW OPERATING INSTRUCTIONS IN THIS MANUAL. ADDITIONAL COPIES OF THE OPERATOR MANUAL ARE AVAILABLE FROM: RICON CORPORATION 7900 NELSON ROAD PANORAMA CITY, CA 91402 (800) 322-2884 or (818) 267-3100 • PRIOR TO USE, INSPECT THE DOOR OPERATORS FOR PROPER FUNCTION, REQUIRED MAINTENANCE, OR DAMAGE. IF A PROBLEM EXISTS, DO NOT USE AND CONTACT AN AUTHORIZED RICON SERVICE TECHNICIAN FOR REPAIR.
b. LOWER LIFT PLATFORM - Press and hold the UP/DOWN switch in the DOWN position until the platform reaches ground level and the outer rollstop opens completely. c. Carefully place wheelchair centrally on platform, facing outward, and LOCK WHEELCHAIR BRAKES. Be certain wheelchair is properly positioned on platform and does not contact outer rollstop and prevent it from locking as the platform rises.
III. MAINTENANCE R egular maintenance of the RICON RDO2900 Series Internal Power Swing Door Operators will provide optimum performance. During the Ricon warranty period, maintenance inspections must be performed by an authorized Ricon service technician at least once every six months, or sooner depending on usage. After the warranty period, maintenance inspections are recommended at the same time intervals. WARNING! THIS RICON PRODUCT IS HIGHLY SPECIALIZED.
B. TROUBLESHOOTING GUIDE The troubleshooting guide is designed to provide a logical starting point to locate general problems that could occur with the power door operators. However, not all possible problems or combinations of problems are listed. For troubleshooting the door operators, refer to Table 3-2 on the following page.
No motion Toggle switch defective. Replace. Wiring connection. Repair. Limit switch at left door defective. Replace. Left motor defective. Replace. Ground connection. Clean/repair. Only left door closes Limit switch at left door defective. Adjust/replace. Wiring connection. Repair. Right motor defective. Replace. Ground connection. Clean/repair. CLOSE MOTION ONLY LEFT DOOR CLOSES SEQUENCE IS CORRECT, BUT OPEN IS CLOSED Actuator arm is Reverse actuator arm. installed upside-down.
C. LIFT DECALS Refer to Figure 3-1. Inspect decals at intervals in Table 3-1. Inspect for chipping, peeling, fading, and illegibility. Order replacement decals by part number given in figure, and apply where shown. FIGURE 3-1: LIFT DECALS AND PART NUMBERS BACK TO TABLE OF CONTENTS 3-4 32DDO05.
