Service manual

Scanner Unit
SM 4-35 M052/M053/M054
Replacement
and
Adjustment
Reinstalling the Front Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the
ring) [C] through the notch.
3. Wind the right end counterclockwise (shown from the machine's front). Wind the left end
clockwise.
 The two blue marks [D] come together when you have done this. Stick the wire to
the pulley with tape. This lets you easily handle the assembly at the time of
installation.