Specifications

28. INTERVAL TIMER PHOTOGRAPHY
The camera is equipped with a built-in interval timer. (Pre-programmed for 10 sec. delay) However, the
interval timer may be set to automatically take pictures at regular intervals of 1 sec. to 1 hr. for time
lapse studies, astrophotography, recording of wild animals, plants growing, etc.
1. While the Interval Timer Button is held down, set the desired
interval timer by pressing the Up or Down Button. (Fig. 91)
2. Be sure to set the Continuous/Single Frame Button (CS) to
Continuous (C) or you will only get one picture, after which the
interval timer will cancel itself. (Fig. 92)4www.butkus.or g
3. Press the Self-timer Button to start the sequence. An exposure
will be taken at the preset interval until the film's end (Fig. 93), or
you push the Interval Timer Button again to switch it off.
* To eliminate electronic beep sound during interval photography,
be sure Power Switch
is in the ON (not ·I)) ) position.
4. The sequence may be temporarily interrupted, or cancelled completely, by pushing the Self
timer Button once. (The Top LCD will return to its normal display mode with the INT Indicator
blinking.) Pressing the Self-timer Button a second time will restart the sequence from the
beginning.
* Pressing the Interval Timer Button during a count-down will cancel the function - after the end of
the on-going count. To immediately stop the sequence, turn the camera power switch off.
5. To clear the interval mode (and turn off blinking INT on the LCD) press the Interval Button
once, your preset time will remain in the interval timer memory for later use.