Specifications

not operate. If the camera will not operate check
that the batteries are installed correctly. If they are
the batteries are probably dead. Replace them
with new batteries.
* When the voltage of the batteries is getting low, the BAT ( Battery Low Warning Signal)
in the Viewfinder will blink on and off. Please change the batteries without delay.
INSERTING THE FILM
(Always avoid direct sunlight when inserting the film.)
1 Pull up the Film Rewind Knob until the Back
Cover snaps open. (Fig. 9)
2. Insert the film in the Film Chamber and push
the Film Rewind Knob down to its former
position.
(Fig. 10)
3. Insert the film leader into the slit on the Film
Take-up Spool. (Fig. 11)
4www.butkus.org
4. Advance the film, making sure that the
sprocket holes on the film are fully engaged on
the Sprocket Teeth. (Fig. 12)