Specifications

Checking Imprinting
After shooting, the imprint mark
-- flashes on the display panel for a few seconds to confirm proper imprinting. The
imprint mark -- and the letter "M" are not imprinted on the photograph.
Resetting the Date and Time (Fig. 88, 89, 90)
1. Each time the Select button is pressed, the flashing digits change in the
following order: Year, Month, Day, Hour, Minute and Colon (:).
2. When the digits to be reset flash, press the Set button until the desired
digits appear. When the Set button is kept pressed, the digits change rapidly.
3. Imprinting is not possible while the Data Back is being reset. When
resetting is complete, press the Mode button until the imprint mark _ appears
on the display panel.4www.butkus.org
Accurately Setting the Seconds
1. Press the Mode button to display the time (Day/Hour/ Minute).
2. Press the Select button so that the colon (:) flashes.
3. Press the Set button accordingly to set the seconds to 0.
4. Press the Mode button.
Battery Replacement
1. Open the back cover.
2. Remove the battery cover retaining screws from the Data Back battery
cover with a small (+) or (-) screwdriver.
Remove the battery cover. (Fig. 91)
3. Remove the battery.
4. Load the new battery with the side marked (+) facing upwards. Then, close
the battery cover using the (+) or (-) screwdriver. (Use lithium battery
CR2025. The service life is about 3 years.) (Fig. 92)
· When the battery is exhausted, the imprinted digits become faint. At that
time, replace the battery.
· Do not open the battery cover except when replacing the battery.
· Keep the battery out of reach of children. If a child swallows the battery,
contact your doctor immediately.