Specifications

Troubleshooting
36
4
Error & Status Messages on the Operation Panel
Important
❒ If an error message that is not included in the following table appears on the
panel display, turn the printer off and on. If this does not clear the error mes-
sage, write down the error number and the message, and contact your sales
or service representative.
Note
❒ The panel display can show only one error message at a time. Printing a con-
figuration page shows all current printer errors. ⇒ P.95 “Printing the Configu-
ration Page”
❒ For more information about the IPDL-C printer driver, see the printer driver's
Help.
Message Description Comments
Add Fuser Oil
(on the lower line)
Fuser oil is low. You can print
about 30 pages after this mes-
sage appears.
Replace the fuser oil bottle.
⇒ P.72 “Replacing the Fuser
Oil Bottle and Ozone Filter”
Add Fuser Oil
(on the upper line)
The fuser oil bottle is empty. Replace the fuser oil bottle.
⇒ P.72 “Replacing the Fuser
Oil Bottle and Ozone Filter”
Add Toner
xxx
The toner indicated by xxx runs
out.
Replace the indicated toner
cartridge.
⇒ P.66 “Replacing the Toner
Cartridge”
Change 120K It is time for scheduled mainte-
nance.
Contact your sales or ser-
vice representative.
Change Fuser It is time to replace the fusing
unit.
Contact your sales or ser-
vice representative.
Change PCU It is time to replace the photo-
conductor unit.
If prints are dirty, replace
the photoconductor unit. ⇒
P.68
“Replacing the Photocon-
ductor Unit”
Change Fuser Cleaner. The fuser cleaner is dirty. Replace the fuser cleaner.⇒
P.76 “Replacing the Fuser
Cleaner”
Change XX It is time to change the unit in-
dicated by XX.
Contact your sales or ser-
vice representative. XX in-
dicates the unit to be
replaced as follows: T1:
Transfer drum R1: Pick-up
roller for the standard tray
R2: Pick-up roller for the
paper feed unit D1: Paper
discharger